If you own an Ultimaker or a simillar machine, you will find this very detailed troubleshooting guide very useful. It describes all possible problems and how to solve them.
Here is an example of "Pillowing", problem I didn't even know existed:
Full guide can be found at:
http://support.3dverkstan.se/article/23-a-visual-ultimaker-troubleshooting-guide
09.24.00
Unknown
problemsolving, ultimaker
Related Posts:
Ultimaker Food Paste Extruder ModDirk Janssen moded his original Ultimaker with food paste extruder based on a large syringe. He started with extruding peanut butter. Follow his Tumblr for future updates, the project is still in the development.Source:http:/… Read More
Ultimaker 2 Vs. Print-Rite Who Wins? Guys from Make.Test.Battle,Ryan and Kash do a casual comparison of the Ultimaker 2 and the Print-Rite DIY 3D Printer from HobbyKing, as well as learn the importance of bed leveling. They do a lot of Nerf toys modificatio… Read More
DIY Ultimaker Tool and Extruder Changer MechanismUltimaker forum user by the name of FoehnSturm presented his approach to toolchanger mechanism on the original Ultimaker machine.It uses a custom modular direct drive extruders with hot end placed in holders mounted on p… Read More
Ultimaker Chocolate Syringe ExtruderHere is an Instructable on how to build a DIY chocolate extruder for Ultimaker original. It is based on 20ml syringe with the inner diameter of 20mm. Syringe is covered with aluminum foil, then Kapton tape. The heater i… Read More
Tribed Print Bed Autocalibration Jeremie Francois developed his own method of automatic print bed leveling and calibration by using some force sensors, Arduino to communicate with modified Marlin firmware and three Z-axis lead screws.Here are videos of his s… Read More